Description
Powered Zone Roller Conveyor – Model CDZA26
NuTech’s Powered zone roller conveyors are chain driven to carry loads like pallets, tires, drums etc. The standard 60″ zones allow for contact-free accumulation to prevent damage to products. Our model CDZA26 are made with heavy duty 2.625″ diameter 7 gauge rollers allowing for a 1,000 lbs per foot capacity when supported on 5 ft centers.
Roller Centers: 4.00” with 40A21 sprockets; 4.50” with 60A15 sprockets; 5.00” with 50A19 sprockets; 6.00” with 60A16 sprockets; 7.50” with 60A16 sprockets; 12.00” with 60A16 sprockets.
Effective Widths: 13”, 19”, 25”, 31”, 37”, 43”, 49”, 54”, 57” and 61”. Also Available from 6” to 61” in 1” increments.
Lengths: Even increments of the roller centers up to 75’. Length also limited to 75 rollers on each side of the drive.
Standard Zones: 60” Long. Also available from 48” to 72” in increments equal to the roller centers. Each zone is controlled by one sensor with self contained logic.
Drive: Standard D16 – side, bottom, near center with live axle drive roller. Drive has cast iron worm gear speed reducer with a standard M03 3/4 H.P. 230/460 TEFC motor.
Electrical Requirements: 24v control voltage in addition to selected motor voltage.
Speed: Standard 30 feet per minute. Also available from 1 to 120 feet per minute.
Rollers: Standard 2607; 2.625 dia., 7 ga. wall tubes with 11/16 hex cold rolled steel axle, spring retained. Standard A51 bearings are grease packed.
Frames: Standard F78 6” deep x 3/16” formed steel on chain box side, 4” x 1-1/2” x 3/16” channel rollers set high on idler side with bolted 5” x 1-1/2” x 3/16” crosstie.
Chain Covers: 1/8” steel with two piece construction for easy access to chain loops.
Pneumatic Clutch: A Standard Ball bearing pilot, end of shaft mount, multiple drive clutch.
Air Requirement: 80 PSI
Supports: SPHH style adjustable set for standard 36” top of rollers located on nominal 5’ centers. Also available from 11” to 42” top of roller at no additional charge.
Capacity: Up to 1,000 lbs. per lineal foot of conveyor with supports on 5’ centers. Several factors affect conveyor capacity. Consult factory to evaluate specific applications.
Guard Rails: Standard G99: No Guard Rail.
Roll Covers: Standard V98: No Roll Cover.
Finish: Standard PP94: Safety Blue, Epoxy Powder Coat.
