Description

Dual CDLR Conveyor – Model CDDB25

NuTech’s Dual CDLR conveyors provide a positive drive for handling heavier loads of castings, totes, and pallets.  Its rugged construction allow for use in wet, oily, and contaminated applications…  This model uses 2.5″ diameter 11 gauge rollers allowing a capacity of 1,000 lbs per foot when supported on 5ft centers

[hr color=”red” width=”95%” border_width=”1px” ]

Roller Centers: 2.812” with 40A21 sprockets. 3.00” with 60A15 sprockets.

Effective Widths: 13”, 19”, 25”, 31”, 37”, 43”, 49”, 54”, 57”, and 61”. Also available from 6” to 61” in 1” increments.

Lengths: Even increments of the roller centers up to 50’. Length also limited to 75 rollers on each side of the drive.
Drive: Standard D10 – bottom, located near center. Drive has cast iron worm gear speed reducer with a standard M03 3/4 H.P. 230/460 TEFC motor.

Speed: Standard 30 feet per minute. Also available from 1 to 120 feet per minute.

Rollers: Standard 2511; 2.5 dia., 11 ga. wall tubes with 11/16” hex cold rolled steel axle, spring retained. Standard A51 bearing are grease packed.

Frames: Standard F22 6” x 1-1/2” x 3/16” channel with bolted 5” x 1-1/2” x 3/16” crosstie.

Chain Covers: 1/8” steel with two piece construction for easy access to chain loops.

Supports: SPHH style adjustable set for standard 36” top of rollers located on nominal 5’ centers. Also available from 11” to 42” top of roller at no additional charge.

Capacity: Up to 1,000 lbs. per lineal foot of conveyor with supports on 5’ centers. Several factors affect conveyor capacity. Consult factory to evaluate specific applications.

Roll Covers: Standard V98: No Roll Cover.

Finish: Standard PP94: Safety Blue, Epoxy Powder Coat.