Description

Belt Driven Live Roller Conveyor – Model BDLR26

Belt driven live roller conveyors are designed to handle products like drums, pails, tires, bundled cardboard or boxes of various size and weight.  The design of the belt driven live roller conveyor allows minimal pressure accumulation with 2.625″ dia., rollers on close centers. The accumulation pressure is adjustable by means of tension rollers mounted underneath.

Standard Specs:

Carrier Roller: 2.625” dia., 7 ga. wall tubes with 11/16 hex cold rolled steel axle spring retained. Standard A51 bearings are greased lubricated.

Roll Centers: 3.00”, 4.00”, and 6.00”

Belting: Standard B25 PVC-120 black, friction surface. Belt is shipped laced and installed on conveyors up to 10’ long. On all other conveyors the belt is shipped loose with lacing installed for field installation.

Between Frames: Standard widths are 39”, 43”, 51”, 57”, 61”, 65”, 73”, 78”, and 84”. Also available from 39” to 84” in 1” increments.

Belt Widths: 12” wide on 39 through 48” B.F., 18” wide on 49” through 84” B.F. conveyors.

Length: 10’ to 80’ in 1” increments.

Standard Sections: 60” long, adjustable with jack screws.

Drive: Standard D46 – end, right hand side, 8” pulley. Drive has cast iron worm gear speed reducers with standard M03 3/4 H.P. 230/460 volt TEFC motor.

Speed: Standard 30 feet per minute. Also available from 10 to 120 fpm.

Bearings: Sealed pre-lubricated, cast iron flange ball bearings.

Frame: 11-3/8” x 1-1/2” x 3/16” formed steel channels.

Drive Pulley: 8” dia. with 1-7/16 dia shaft crowned and lagged. Mounted in 2 bolt flange bearing.

Take-Up Pulley: 4” dia. with 1-3/16” dia. shaft, crowned mounted in 2 bolt flange bearing.

Snubber Roller: 2.5 dia. 11 ga. wall tubes with 11/16 hex cold rolled steel axle, spring retained. Standard A53 bearings are grease packed with front and back seals.

Tension Roller: 1.9 dia. 11 ga. wall tubes with 7/16” hex cold rolled steel axles, spring retained. Standard A11 bearings are grease packed. The same for return rollers.

Capacity: 1000 pounds per lineal foot. Maximum 4000 pounds unit load per section. Total conveyed load not to exceed capacity shown in chart.

Supports: SPHH style located on nominal 5’ centers available for top of carrier rollers above 12” to 42” at no additional charge. No support required for minimum elevation 12” top of bed rollers.

Roll Covers: Standard V98: No Roll Cover

Finish: Standard PP94: Safety Blue, Epoxy Powder Coat.